Tools

Here’s how to cut the circle with a circular saw

Cutting free circles will never be good. Here it needs aids.

Here's how to cut the circle with a circular saw

RETTHOLT: If you have a straight table or a right-handedness, you can do a test cut, measure and write the goal on the table. If you want to make it even easier, you can cut yourself a few spacers. Photo: Øivind Lie

Here's how to cut the circle with a circular saw

CONTROL BOX 1: You need a strip of a veneer sheet 18 mm thick and 120 mm wide, and a strip of fiberboard 6 mm thick and 220 mm wide. You decide the length yourself. Photo: Øivind Lie

Here's how to cut the circle with a circular saw

CONTROLS 2: Staple and glue the plates and trim the excess on wood fiberboard. Photo: Øivind Lie

Here's how to cut the circle with a circular saw

CONTROL BOX: Do you buy a guide rail, you have a tool that is completely on the floor with a table saw. Photo: Øivind Lie

Here's how to cut the circle with a circular saw

ALL VINKLER: Quick angle with measuring scale from 0 to 90 degrees. It costs 75 kroner at Aurus. no Photo: Manufacturers

Here's how to cut the circle with a circular saw

This was just a European

Here's how to cut the circle with a circular saw

This board is on its own bone

Here's how to cut the circle with a circular saw

Test: Cheapest case is best

A circular saw is a good aid if you want to build furniture or add lists. The challenge is to cut right.

– Should you have absolutely correct cuts, you must have something to control, says Johan Burmann in Burmann’s Construction to Click. no.

– With a table that you stuck with forces, or with a guide, he expands.

Use a table

From Family Handyman we have picked this tip: Find yourself a straight table or use a right hand. Attach it to force a disc and make a test cut. Take measurements of the distance between the cut and the right table.

Our tip is to write down the goal on the right table, or even easier: create spacer blocks.

Create your own guide

Gary Katz in Fine Homebuilding has a simple hint of how to make your own guide: Some album reviews are probably all you need.

We start with a 6 mm wood fiberboard and an 18 mm veneer plate. The length of the shine determines yourself. The width of the fibreboard must be 220 mm, and the veneer plate shall be 120 mm.

If you have to cut to the width, you can easily do this with a hand saw.

It is important, however, that the long side of the veneer plate to control the saga is quite right. The simplest is therefore to use the so-called factory side of the disc.

If you get the slices cut by the wooden handler, it does not matter which page you are using.

Fit the plates

Mount the veneer plate on the fibreboard. Glue and pin from the top.

Apply the saw and cut so that the fibreboard is in the correct width.

The part of the base underneath the engine must be against the veneer plate.

Now you have a guide rail that you can put right on the marks, squeezing and sawing in the way.

Sheath Table

A quick angle is an ingenious tool to use with the circular story. It provides facility for saga when cutting out angles from 0 to 90 degrees. Then you have a handy and more portable alternative to the big cow and yeast story

You can also create a simpler variant yourself, such as 90 and 45 degrees robes.

Get more about snoring and tools: Follow me on Facebook and visit the Toolbox.

Also read:

Here you can ask about refurbishment

To cut a plasterboard

Stylish with sliding doors

Nine things that make parents terrified

.

Leave a Reply

Your email address will not be published. Required fields are marked *

Adblock Detected

Please consider supporting us by disabling your ad blocker